WIP: Sun Hare

Well, I’ve tidied up the model. It doesn’t show at all in the picture, but basically I went over every inch of it filling in sundry holes and deep cracks and taking off lumpy bits I didn’t like while improving the lumpy bits I did like. So while it’s going to look like I just slapped the wax on, I didn’t. Now I’m wondering if the figure is just a bit too skinny. I’ll make the other one and then see, but it might want a bit more wax on the very thin bits. If I leave it like this, and even if I don’t, I think I’ll have to replace the midsection with harder wax, as the armature is bending. I can hold it in place with barbecue skewers, but the more solid the better.

Leave a Reply

Your email address will not be published. Required fields are marked *